![what timney trigger will fit a springfield 1898 what timney trigger will fit a springfield 1898](https://i.imgur.com/0ctznNN.jpg)
The probable importance of these various parts in the perfection of the trigger pull is in the order given. Should the action still be faulty, it will be necessary to interchange the parts until a combination of cocking piece, sear and sear spring, trigger, and mainspring is found which will correct the difficulty. Should this procedure fail to produce the desired degree of smoothness in the action or the desired correction in trigger weight, the heel of the trigger and the point at which it comes in contact with the receiver should be inspected and any roughness removed by stoning. Sharp corners and edges should not be rounded off. All burrs should be removed by stoning and all surfaces which are not perfectly smooth should be polished by stoning. (2) When creep, as defined in paragraph 28 c (4), is found in a trigger, or when the trigger pull does not fall within the prescribed limits, examine the sear nose and sear notch for burrs or rough surfaces. A loose trigger pin, especially if it allows side play, should be replaced. (1) Burrs on bearing and heel of trigger should be removed with a sharpening stone, care being taken not to remove too much metal. Creep should be eliminated as much as possible, whenever found, as it prevents the proper squeeze of the trigger, which is essential to the proper firing of the rifle. (4) “Creep” is any movement of the trigger that can be felt by the finger after the slack has been taken up and before enough pressure is applied to release the sear. (1) Trigger pull for rifles in service must be greater than 3 pounds but should not exceed 6 pounds.